GPS INFO

Your Cutting-Edge gps Resource

best gps navigation portable Article


best gps navigation portable Navigation

 

Portable Gps Mapping Systems
Best Gps Navigation Portable
Handheld Gps System
Portable Gps System Reviews
Gps Receiver
Gps Navigation System



Below, you'll find extensive information on leading best gps navigation portable articles and products to help you on your way to success.

Using Gps For Computer And Ntp Server Timing
By David Evans
The system is a worldwide navigational system operated by the US military. The system is maintained by USNO, the United States Naval Observatory. The Global Positioning System is implemented from space by 24 satellites in high orbit. Each satellite has precise timing equipment that can be used to triangulate position for navigational purposes. Low-cost antennas and receivers are now widely available and provide precise time and frequency information worldwide.

This article presents an introduction to using the system for computer timing applications. It describes the equipment that can be utilised to provide a precise time resource for computers and computer networks.

All of the orbiting satellites have on-board precise timing references that can be utilised by time servers to provide accurate time. Each satellite continually broadcasts accurate time and positioning information. This information can be received by a receiver and externally mounted antenna. The timing information received is referenced to UTC time. The system is a free to air service requiring no set-up or subscription fees.

Many Network Time Protocol (NTP) server systems utilise time as an external timing reference to synchronise Windows, LINUX, UNIX and other operating systems and network infrastructures. is an ideal time and frequency source because it can provide highly accurate time anywhere in the world using relatively cheap components.

Each satellite transmits a very low-power radio signal at two frequencies; L1 and L2. L1 is the civilian frequency band transmitted at 1575 MHz, while L2 is used for military positioning purposes. The radio signal transmitted by each satellite can easily pass through material such as glass and plastics but are blocked more substantial materials used in buildings. The signals travel by line of sight. The ideal location for a antenna is on a rooftop with a good view of the sky.

The radio signals can be received by a low-cost antenna. The antenna is essentially a high gain amplifier, which is used to amplify and transmit the weak radio signals down a coax cable to a receiver.

The cable length that can be utilised between a antenna and receiver is critical. Cable distance is determined by the

relative quality of cable utilised and the gain of the antenna. High antenna gain and high quality coax allows for much longer cable runs.

GPS signal amplifiers can be fitted inline on the coax cable to boost the signal and increase cable length. amplifiers are generally powered from the coax cable. The higher the gain provided by the amplifier, the longer the cable can be extended.

Roof-mounted antennas can be prone to lighting strikes or other voltage surges. A lightning strike up to a quarter of a mile away can damage electronic components. Therefore, it is recommended that a surge suppressor be fitted. Lightning or surge suppressors are installed inline on the cable and redirect any surge to earth. Various types of surge suppressor are available, from gas discharge devices to solid-state multi-strike devices.

GPS receivers decode the received signal from the antenna and provide easily readable information in a serial format. Microsoft Windows, Linux and Unix PC's or NTP Time Servers can utilise the timing information from the receiver for synchronisation purposes. Many different protocols are utilised, the most popular being NMEA. The NMEA protocol was developed by the National Marine Electronics Association. The protocol specifies a set of sentences that contain time and positioning information obtained by the receiver. The messages can be easily decoded by a standard PC or NTP server to provide precise timing information.

To summarise, the system is an excellent source of precise time for NTP server systems or for synchronising stand-alone Windows, LINUX and UNIX PC's. By using relatively low-cost components, the Global Positioning System can provide time sensitive applications with precise timing information.

Article Source: http://www.NewArticlesOnline.com

Dave Evans has provided a technical authoring service to the network timing and telecommunications industries for many years. Click here for more information on Windows, LINUX and UNIX timing and GPS NTP Server systems.


 

We strive to provide only quality articles, so if there is a specific topic related to gps that you would like us to cover, please contact us at any time.

And again, thank you to those contributing daily to our best gps navigation portable website.

Additional Related Resources      
© 2006 GPS INFO. All rights reserved. gps